ok this y i asked look;-------------------------------------------------------[Video Win] ;Enter the width and height of the resolution you want to set here. ;The optimal resolution is 320x240, but if your video card has problems ;You may want to try 640x480.Width = 640Height = 480;Width = 320;Height = 240 ;This is the color depth at which to run MUGEN. You should set it to ;16 bit color unless your video card has problems with it. ;16-fastest, 24,32-slower, 8-slowest/worstDepth = 16 ;Set this parameter to 0 to disable screen stretching, and set it to 1 if ;you want to scale it up to fit the current resolution.Stretch = 1 ;Set this parameter to use a resolution-doubling filter. You will ;need a fast machine to use these filters. You will need to increase ;the screen resolution to at least 640x480 for these modes. ;0 - off ;1 - diagonal edge detection ;2 - bilinear filtering ;3 - horizontal scanlinesDoubleRes = 4 ;DirectX mode ;Choose from Hardware, Software, Windowed, Overlay, Safe and None ;Hardware and Software run in full-screen. Windowed and Overlay ;run in a window. The windowed modes require you to set Depth to ;whatever color depth you are using for you desktop. The best results ;are when you run in 16-bit color. There is no advantage to running ;in 32-bit color. If Hardware, Software and Windowed fail, try Safe. ;None uses GDI to draw, so it's very slow. Use None only if ;you cannot get anything else to work. ;Overlay is not supported by all video cards, but can be faster than ;Windowed if it works.;DXmode = HardwareDXmode = Windowed ;Set to 1 to enable vertical retrace synchronization. Do not enable ;if BlitMode = PageFlip.VRetrace = 0 ;Drawing mode ;Choose from Normal and PageFlipBlitMode = Normal
gswang said, October 06, 2007, 07:49:42 ambut what about thisWidth = 640Height = 480;Width = 320;Height = 240 That's fineWhy is this like this?: [mcode] ;Set to 1 to enable vertical retrace synchronization. Do not enable ;if BlitMode = PageFlip.VRetrace = 0 ;Drawing mode ;Choose from Normal and PageFlipBlitMode = Normal[/mcode]Shouldn't it be?:[mcode] ;Set to 1 to enable vertical retrace synchronization. Do not enable ;if BlitMode = PageFlip.VRetrace = 0 ;Drawing mode ;Choose from Normal and PageFlipBlitMode = Pageflip[/mcode]
in the video linux section(i think that's what it's called) of mugen.cfg it says something about enabling fullscreen mode. look there.
