YesNoOk
avatar

Non-transparent animation (Read 340 times)

Started by Stormrider, November 30, 2007, 12:56:14 am
Email this topic
View printable version
Share this topic:
Page 1 of 11   Go Down

Stormrider

Non-transparent animation
#1  November 30, 2007, 12:56:14 am
  • avatar
  • **
I've just created an animated lifebars with static/noise effect. They're fine but they have some degree of transparency. This always happens to me when I create animations. I've tried adding trans = none, just after the animation reference, but it makes no difference. What am I doing wrong?

Cyanide

Re: Non-transparent animation
#2  November 30, 2007, 01:05:33 am
  • ******
  • Legendary XIII
  • I am the eye of the storm to come!
    • New Zealand
    • network.mugenguild.com/cyanide/
Are you adding an A or A1 to the animation setup. Have you set your pallete up so the transparent colour is not involved in the bars.

You still need a 256 colour pallete with a correct transparency setting even if you're not using shared pallete.


In M.U.G.E.N there is no magic button

They say a little knowledge is a dangerous thing, but it's not one half so bad as a lot of ignorance.

Stormrider

Re: Non-transparent animation
#3  November 30, 2007, 01:28:49 am
  • avatar
  • **
It was the A1. I didn't know what it was for. Now I know. Thanx. :)
Page 1 of 11   Go Up