OFFSET??

[booboomc21]

I just tried to complete adding a special move to my character following the ultimate mugen tutrial 3. Everything went well until i changed the offset. i get an error that says "is not a valid integer value. but i followed the tut to the tee. i have 2 screens so i watched and did at the same time. Can anybody help me figure it out? thank you.
here is my cns info for the move.

; Light Fireball
[StateDef 999]
type = S
movetype= A
physics = S
juggle  = 1
velset = 0,0
ctrl = 0
anim = 999
poweradd = 20

[State 999, 1]
type = Projectile
trigger1 = AnimElem = 3
projanim = 1000
projhitanim = 1001
projpriority = 1
projheightbound = -240, 100
projedgebound = 100
projscreenbound = 100
projshadow = -1
offset = 91,19
velocity = 3
attr = S, SP
damage   = 135
animtype = heavy
guardflag = MA
hitflag = MAFDP
pausetime = 10,10
hitsound   = 5,2
sparkxy = 500,500
guardsound = S6,0
ground.type = Low
ground.slidetime = 25
ground.hittime  = 25
ground.velocity = -6
air.animtype = Back
air.velocity = -4,-6
air.juggle = 3
air.fall = 1
down.velocity = -4,-6
down.hittime = 30
down.bounce = 0

[State 999, end]
type = ChangeState
trigger1 = AnimTime = 0
value = 0
ctrl = 1

And when i try to test in mugen i get this...

Error Message:
Error in command: Light Fireball
Error in CharlieMac.cmd
Error Loding chars/ffchartest/ffchartest.def
Error loading p1

[ssjsongoku]

Error in CharlieMac.cmd

Did you check to see that you didn't make an error in the CMD?

[#Shaun]

Error Message:
Error in command: Light Fireball
Error in CharlieMac.cmd
Error Loding chars/ffchartest/ffchartest.def
Error loading p1

The problem is your CMD file, not the CNS. Post your CMD code.

[booboomc21]

;Light Fireball
[State -1, Light Fireball]
type = ChangeState
value = 999

Thats all it says.

[Byakko]

Can you look at the .cmd file of KFM and read what's inside, at least starting from the statedef -1? You need to give your command an actual command to perform as well as triggers.

[booboomc21]

ok i figured it out. i was putting a 4 at the end of my command. it needed to be an x so now it works. thanks for you guys help.